TV Mounts / ECHOGEAR
ECHOGEAR EGLL2 Low Profile Fixed Mount
150lb capacity, 2.25 inches from the wall, and properly documented.
Overall score 7.5/10
Pros
- + 150lb capacity and VESA 600x400 handle essentially any consumer TV up to 90 inches
- + 2.25 inches from the wall gives an almost flush, wall-art look
- + UL certified and load-tested to four times its rating, with public install documentation
- + Lateral slide means you can still centre the TV even if your studs are not
Cons
- − No tilt at all — a poor choice above a fireplace or anywhere you sit below the screen
- − Requires two studs, so single-stud installations are out
- − No cable management raceway
- − ECHOGEAR does not publish a levelling figure
ECHOGEAR EGLL2 Low Profile Fixed Mount review: what the specs say
150lb capacity, 2.25 inches from the wall, and properly documented. At $34.99, ECHOGEAR's 2019 model sits among the cheapest we cover — the TV Mounts we compare run from $27.99 to $429.99. It scores 7.5/10 overall, calculated from published specifications across 8 categories rather than from a subjective impression.
Its strongest showing is Value at 9.5/10 — capability and build relative to price. The weakest is Adjustability at 2.0/10, which is the trade-off to weigh before buying: if that is the specification you care about most, one of the alternatives below will serve you better.
Worth knowing before you buy: no tilt at all — a poor choice above a fireplace or anywhere you sit below the screen; and requires two studs, so single-stud installations are out. Every specification on this page comes from ECHOGEAR's own documentation or a verified retail listing — where a figure is not published, the table says so rather than estimating it.
Specifications and price last verified . Report an error
Full Specifications
| Mount Type | Fixed |
| Screen Size Range | 42-90 inches |
| Max Weight Capacity | 150 lbs |
| Max VESA Pattern | 600x400 |
| Tilt Range | None |
| Swivel Range | None — but the TV slides laterally on the wall plate to centre it |
| Extension from Wall | Not applicable |
| Profile Depth | 2.25 inches |
| Stud Spacing | Minimum 16-inch wood or steel studs; concrete requires 16-inch minimum fastener spacing |
| Post-Install Levelling | Post-install levelling is advertised but ECHOGEAR does not publish a figure in degrees |
| Cable Management | No raceway; the pull-string release tilts the TV forward for port access |
| Connectivity | 16-inch stud spacing, Concrete and block with appropriate fasteners |
| Material | Powder-coated steel |
| Warranty | 12 months |
Compare ECHOGEAR EGLL2 Low Profile Fixed Mount With
Cheaper Alternative
PERLESMITH PSLLK1 Fixed Low-Profile Mount — $27.99
Premium Alternative
ECHOGEAR EGLT1 Tilting Mount — $36.99